Wiring - Navman Halo Qube 2 Installation Manual

Halo QUBE 2 | Installation Guide V1.0

Wiring

Cable A
Has a long cable with a RJ45 Plug, a short cable with a DB9 plug, and a single cable with bare ends for
all other connections.
Cable B
Has an RJ45 socket very close to the main plug (DB15), and a single long cable with bare ends for all
other connections.
Power Connection - Bare wires
Cable A
Red
Pink
Black
Important Notice
If fitting a MDT-800 (Mobile Data Terminal) the main power connection (red wire) must be
connected to +12 V DC only. The Qube 2 ignition and Multi IO lines may still be connected to
24 V DC.
MDT or PDT Connection
RJ45 Connector - Cable A (Male plug), Cable B (Female socket)
Cable A
Pin - 1
Pin - 2
Pin - 4
Pin - 5
Cable B Function
Red +12/24 V
Pink Ignition
Black
Cable B Function
Pin - 1
Pin - 2 +12/24 V
Pin - 4 Serial RxD
Pin - 5 Serial TxD
Description
Main Power Connection - Connect to
a fused supply
Positive input from vehicle when the
key is in the IGNITION position (not
the accessory position). This signal
must remain on DURING starting
of the vehicle - Connect to a fused
supply.
GND Vechicle ground / chassis connection
Description
GND Ground
Power
Serial data Input
Serial data Output
8