Quick Install - 3-Wire Basic Tracking - Navman Halo Qube 2 Installation Manual

Quick Install - 3-Wire Basic Tracking

Power Connection
Wire Colour
Red
Pink
Black
Note: Please individually insulate any bare ends that are not connected.
Tax Disk Antenna
Recommended Mounting
• Under the driver or passenger's seat.
• In or under the dash.
• In the boot / trunk area.
• Where it is not excessively hot.
• Where it is dry.
• Where there is not excessive vibration.
• Should allow MDT/ PDT connection.
• Should allow the diagnostics LED's to be seen
• Should allow suffi cient clearance to plug and unplug the connectors while mounted.
Status LED Indicators
Display
LED
Power
Slow Flash
GPS
GPRS
Function Description
+12/24 V Main Power Connection - Connect to fused supply
Positive input from vehicle when the key is in the IGNITION
position (not the accessory position). This signal must
Ignition
remain on DURING starting of the vehicle - Connect to a
fused supply.
GND Vehicle ground / chassis connection
Normal
State Operation
On

Off
On

Off
On

Off
Halo QUBE 2
Black = Ground
Description
Power ON, Unit awake
Sleep mode
No Power -
Note: The Qube 2 should always be powered.
GPS fi x
No GPS fi x
Data connection to cellular network
No data connection
5
| Installation Manual V1.0
Red = +12/24 V Battery
Pink = ignition "ON"
(NOT Accessories)