Wiring; Power Connection; Connecting The Auxiliary Devices - Navman Qube 2.5 Installation Manual

Qube 2.5 | Installation Manual

5 Wiring

Connection Cable
The Connection cable has an RJ45 socket very close to the main plug (DB25), and two long cables
with bare ends for all other connections. The 4-wire cable is the minimal requirement for tracking
only. The 18-wire cable is used to connect auxiliary devices.

5.1 Power Connection

4-Wire cable
Red
Brown
Orange
Black
IMPORTANT NOTICE
• Connect to a fused supply
• Insulate bare wires

5.2 Connecting the Auxiliary Devices

The Qube 2.5 is equipped with additional IO that can be connected to auxiliary devices in the
vehicle. These allow the Qube to generate events based on inputs from these devices.
• Multi-IO. Each Multi-IO can be confi gured as digital input, analogue input or digital output
• Serial. There are two RS232 serial ports that can be confi gured as serial capture ports or
MDT. For serial Capture, a confi guration string is sent via the server
Qube 2.5 Installation Manual.indd 10 Qube 2.5 Installation Manual.indd 10
Function Description
+12/24V Main Power Connection. This connection should be fused
Ignition Positive input from vehicle when the key is in the IGNITION
position (not the accessory position). This signal must remain
on DURING starting of the vehicle. This connection should
be fused
Backup Battery If required, connect external battery here for continued
operation when main power fails.
GND Vehicle ground / chassis connection
10
7/8/08 12:09:00 PM 7/8/08 12:09:00 PM