Table of Contents
Advertisement
User Guide
The auto rebuild function cannot be performed (the rebuild by hot swap is disabled)
in the RAID configuration (except RAID0)
θ How long did you wait between the removal of the defective hard disk and the
installation of the new disk?
→ In order to let the auto rebuild function operate normally, wait at least 90 seconds
after you have removed the defective hard disk to install the new disk.
θ Is the Disk Array Controller setting correct?
→ Refer to your Disk Array Controller User's Guide.
θ Is the consistency check under execution?
→ Complete the consistency check before starting the rebuild.
65
www.nec-computers.com
Advertisement
Table of Contents
