Disc Title - JVC XM-228BK Instructions Manual

ENTER
or
or
28
4 Select "(space)" and press SET on the main unit or the remote control unit.
5 Press DISPLAY/CHARACTER on the main unit or the remote control unit until the
numbers "01234" are displayed.
6 Select "1" and press SET.
7 Select "2", "3" and "4" in the same way.
When you enter "3", the title name scrolls to the left to display "4".
To check the title name, press 6 on the main unit or 3 on the remote control unit.
Then the title name starts scrolling from the beginning.
8 Go to step 5 .
Editing the title name:
If a wrong character has been input, clear it using 7STOP/CANCEL on the main
•
unit or CANCEL on the remote control unit.
• To clear a particular character which has been input:
First, press 1 or ¡ on the main unit or the remote control unit to align the
•
cursor with the character, and press 7STOP/CANCEL on the main unit or
CANCEL on the remote control unit.
• Next, select the correct character and press SET on the main unit or the remote
control unit.
5 Press ENTER on the main unit or the remote control unit.
The display shows "EDITING" and the TOC indicator lights up.
Next, the display shows the disc title name and then shows the track number and the
total playback time.
• If the disc title is longer than 11 characters, it scrolls on the display.
• After editing the title track, the name of the track is not displayed.
6 Press 0 on the main unit or the remote control unit to
eject the MD.
The data in the memory is written in the MD before it is ejected.
The display shows "UTOCwriting" during MD write operation.
• Be careful not to apply impact to the MD recorder during writing data in the
memory in the MD. Otherwise the recording may be unplayable later.
• The data in the memory is written in the MD also when the unit is switched to
Standby mode while "EDITING" is being displayed.
To exit editing:
Press TITLE on the main unit or TITLE/EDIT on the remote control unit before pressing
ENTER in step 5.

(Disc Title)