Joining Tracks (Join) - JVC XM-228BK Instructions Manual

or
ENTER
or
or
TITLE
/EDIT
or
20
5 Fine-adjust the track marking position.
Turn the jog dial on the main unit or 4 or ¢ on the remote control unit.
The track marking position can be fine-adjusted in the range of ±128 positions (approx.
±8 sec.).
As you adjust, the track marking displaces slightly and the 4-second section from the
newly divided point will be played repeatedly.
• After completing the fine-adjustment, go to step 6.
To cancel the current track marking position, press 7STOP/CANCEL on the main
•
unit or CANCEL on the remote control unit and repeat from step 3.
6 Press ENTER on the main unit or the remote control unit.
The change made above is entered
temporarily in the memory. The display
shows "EDITING" and the TOC
indicator lights up.
TOC indicator:
The TOC indicator shows that the MD has new data that should be memorized.
The data writing operation is done by ejecting the MD or by turning the power off.
Before the MD is ejected or the power is turned off, "UTOCwriting" is displayed until
data is completely written.
7 Press 0 on the main unit or the remote control unit to
eject the MD.
The data in the memory is written in the MD before it is ejected.
The display shows "UTOCwriting" during MD writing operation.
• Be careful not to apply impact to the MD recorder during writing data in the
memory in the MD. Otherwise the recording may be unplayable later.
• The data in the memory is written in the MD also when the unit is switched to
Standby mode while "EDITING" is being displayed.
To exit editing:
Press EDIT on the main unit or the TITLE/EDIT on the remote control unit before pressing
ENTER in step 6. Then, press the same button repeatedly until the editing track number is
displayed.
To restore the original track from the divided tracks:
Use the JOIN editing function mentioned below.

Joining tracks (JOIN)

Two adjacent tracks can be joined into a single track by deleting the unnecessary track
marking. This also makes it possible to join more than two tracks into a single track or a
piece of music divided into multiple tracks into a single piece. The track numbers after the
joined tracks are decremented automatically.
1 Press EDIT on the main unit or the TITLE/EDIT on the
remote control unit to select "JOIN".
The JOIN indicator lights up.
Each press of the button switches the editing functions as follows.
• When TITLE/EDIT on the remote control unit is used, the disc title is displayed
after "ALL ERASE".
DIVIDE
MD total playing time display (Disc title)
JOIN MOVE ERASE
1 2 3 4 5
6 7
ALL ERASE
Blinks
1 2 3 4 5
6