Playback; Normal Playback - JVC XM-228BK Instructions Manual

Playback

or
or
or
8

Normal playback

The basic operation for playing an MD is described below. When no MD is loaded yet,
"NO DISC" is shown on the display.
1 Load an MD.
Hold an MD with the side on which an
arrow is marked facing up, and insert it into
the slot in the direction of the arrow.
The MD will be pulled in automatically
from the middle.
• If the MD has a disc title, the display
shows the disc title then the number of
tracks and total playing time of the MD.
• The tracks in the MD appears on the
music calender.
Note: To allow easy insertion, insert the MD along the upper part of the MD insertion
slot.
Caution
• Do not mistake the MD insertion direction, otherwise
malfunction will result.
Shortcut:
You can insert an MD in Standby mode. Then, the power is turned on and the MD is
pulled in automatically.
2 Press 6 on the main unit or 3 on the remote control unit.
Playback starts.
The 3 indicator blinks for a while and then stays lit.
The playback level for the L and R channels are shown on the level indicators.
• If the track has a title, the track title will be displayed before playing the track.
• The track number that has been played disappears from the music calender.
• The MD automatically stops when the last track of the MD has finished playing.
Shortcut:
When you press 6 on the main unit or 3 on the remote control unit in Standby mode,
power is turned on and the MD is automatically played. However, if no MD is loaded,
"NO DISC" is shown on the display.
To stop the MD:
Press 7 on the main unit or the remote control unit.
• If the MD has a disc title, the display shows the disc title then the number of tracks and
total playing time of the MD.
To eject the MD:
Press 0 on the main unit or the remote control unit.
The MD is ejected and the display changes as follows:
Number of tracks Total playing time