Advertisement
•
Note: Prior to connecting the gas supply it is advisable to blow out the gas supply so that any dirt which may be present in the pipe is
cleared and cannot enter the gas valve or pilot burner and so cause a blockage
•
With the supply connected check the installation pipework for gas soundness. In the United Kingdom check in accordance with the
current edition of B.S. 6891. In the Republic of Ireland check in accordance with the rules in force.
FITTING THE CERAMIC FIREBOX WALLS & FUEL BED
Figure 5
Figure 6
Figure 9
1.
Open the side door by turning the handle clockwise.
2.
Remove the two screws from the ceramic support bracket. The side of the support bracket can now
be removed. (See figure 5)
3.
Remove the ceramic packs from the firebox. Carefully unpack the ceramic pieces.
4.
Fit one of the ceramic side walls into the slot of the ceramic support bracket at the far side of the
firebox. Leave sufficient space to insert the edge of the rear wall behind the side wall. Fix the side wall
into position using the retaining clamp. (See figure 6).
5.
Fit the edge of the rear ceramic wall behind the side wall. The rear ceramic wall will rest on the
base of the casting (see figure 7)
6.
Fit the rear base piece into position behind the burner and position it so that its rear is flat against
the rear ceramic wall. (See figure 8).
7.
Fit the front base piece locating the ledge / slot that is underneath the base piece over the metal
burner strip. (See figure 9).
8.
Place the 5 coal pieces on the base pieces (See figure 10)
The three large coals should be at the front, the two small coals at the back.
9.
Fit the remaining ceramic side wall into the slot of the ceramic support bracket previously
removed. Fix the side wall into position using the retaining clamp.
10. Fit the ceramic support bracket in place using the two screws previously removed.
11. Close the door and secure shut by turning the handle clockwise.
Figure 7
Figure 10
Figure 8
5
Advertisement
