Cisco FastHub 100 series Installation Manual page 69

rpsappb Page 7 Monday, September 14, 1998 8:19 AM
Table B-2 Error Descriptions and LED Status (Continued)
RPS LED Status Condition
AC 1 or 2 LED is amber FAIL
or off.
Reading Error Messages on Cisco 2600 and 3600 Series Routers
Error Indicators, Descriptions, and Solutions
Console Message Issued Upon Correction of Error:
When an external device console monitor screen displays the Cisco IOS
software prompt (routername > or routername #)
Supply DC condition is now normal."
When an external device console monitor screen displays the Cisco IOS
software prompt (routername > or routername #)
Supply DC condition is now normal."
When an external device console monitor screen displays the ROMMON
prompt (rommon #>) no console message is issued when the error is
corrected.
SNMP Trap Issued Upon Correction of Error:
ciscoEnvMonRedundantSupplyNotification is generated. The varbinds
included are ciscoEnvMonSupplyStatusDescr and
ciscoEnvMonSupplyState. The value of ciscoEnvMonSupplyState will be
normal.
Console Error Message:
When an external device console monitor screen displays the Cisco IOS
software prompt (routername > or routername #)
Redundant Power Supply AC FAIL condition."
The Cisco IOS software checks the condition every 30 seconds. If the
condition still exists, the error message redisplays.
When an external device console monitor screen displays the ROMMON
prompt (rommon #>)
"*** System Environmental Interrupt ***
WARNING: REDUNDANT POWER SUPPLY AC FAIL BIT IS
ASSERTED."
"Redundant Power
"Redundant Power
"System detected
Troubleshooting the Cisco RPS B-7