Cisco FastHub 100 series Installation Manual page 43

rps4 Page 7 Monday, September 14, 1998 8:19 AM
Step 3
Figure 4-4 Connecting a One-to-One Cable for Quasi-Redundant Power
AC INPU T 1
AC INPU T 2
100-2 00 V~ 50/60 Hz
100-2 00 V~ 50/60 Hz
10-5 A 1000 W
10-5 A 1000 W
Figure 4-5 Connecting a Two-to-One Y-Cable for Fully Redundant Power
AC INPU T 1
AC INPU T 2
100-2 00 V~ 50/60 Hz
100-2 00 V~ 50/60 Hz
10-5 A 1000 W
10-5 A 1000 W
Connect the other end of the one-to-one cable or the two-to-one cable to a
rear-panel connector on the Cisco RPS, as shown in Figure 4-4 and Figure 4-5.
DC OUTP UT 1
DC OUTP UT 2
DC OUTP UT 1
DC OUTP UT 2
DC OUTP UT 3
DC OUTP UT 4
DC OUTP UT 3
DC OUTP UT 4
Connecting Cables 4-7
Connecting Hubs