Cisco FastHub 100 series Installation Manual page 34

rps3 Page 4 Monday, September 14, 1998 8:17 AM
Cables
Table 3-1 Cable Order Numbers
Redundancy
Configuration For Use With
Quasi-Redundant HP 10BaseT Hub-16M, FastHub 100
series, FastHub 200 series, and
FastHub 300 series 100BaseT hubs,
Catalyst 1900 and Catalyst 2820 series
switches, Catalyst 2900 series XL
switches, Cisco 2600, 3600, and 4000
series routers
Cisco 2500 series routers and
Cisco MC3810 multiservice
concentrators
Fully Redundant FastHub 100 series, FastHub 200 series,
and FastHub 300 series 100BaseT hubs,
Catalyst 1900 and Catalyst 2820 series
switches, Catalyst 2900 series XL
switches, Cisco 2600, 3600, and 4000
series routers
Cisco 2500 series routers and
Cisco MC3810 multiservice
concentrators
Redundant with FastHub 100 series, FastHub 200 series,
Reboot and FastHub 300 series 100BaseT hubs,
Catalyst 1900 and Catalyst 2820 series
switches, Catalyst 2900 series XL
switches
1. The cables come in one length only. Custom cable-lengths are not available. Excessive voltage drop and marginal or failed operation
can occur with cables of different lengths. Use of cables other than the ones provided can cause damage to the Cisco RPS or router.
2. If you have a Catalyst 1900 series switch (WS-C1900, WS-C1912, or WS-C1900C), depending on when it was manufactured, you
might need a special cable. CAB-RPS-2218A(=) used for pre-EN or-A models of the Catalyst 1900 series and Catalyst 2820 series
switches. Contact Cisco's Technical Assistance Center (TAC) at 800 533-2447, 408 526-7209, tac@cisco.com, or
http://www.cisco.com. Be ready to provide the serial number of your Catalyst 1900 series switch and the part number of the special
.
cable (72-1327-01)
3-4 Cisco Redundant Power System Hardware Installation Guide
Cable Order
Cable Description Number
One-to-one cable, 22-pin to CAB-RPS-2218=
1
18-pin, 4 ft (1.22 m)
One-to-one cable, 22-pin to CAB-RPS-2208=
1
8-pin, 4 ft (1.22 m)
Two-to-one cable, 22-pin to CAB-RPSY-2218=
1
18-pin, 4 ft (1.22 m)
Two-to-one cable, 22-pin to CAB-RPSY-2208=
1
8-pin, 4 ft (1.22 m)
One-to-one cable, 22-pin to CAB-RPS-2218=
1
18-pin, 4 ft (1.22 m)
2
2