Cisco FastHub 100 series Installation Manual page 39

rps4 Page 3 Monday, September 14, 1998 8:19 AM
Connecting External Devices to the Cisco RPS
Note If you want to connect an additional external device to a Cisco RPS that is already
powered up, you can do so without interrupting power to the Cisco RPS or any other
external devices that are already connected. Be sure to connect your cable to the Cisco RPS
first and then to the external device.
Warning
device.
Warning
Warning
removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker on
the panel board that services the DC circuit, switch the circuit breaker to the OFF position,
and tape the switch handle of the circuit breaker in the OFF position.
Warning
unplug the power cord.
Warning
shock, disconnect the two power supply cords before servicing the unit.This unit might
have more than one power cord. To reduce the risk of electric shock, disconnect the two
power supply cords before servicing the unit.
Use the Cisco RPS (model PWR600-AC-RPS) only to power the external
Attach only the Cisco RPS (model PWR600-AC-RPS) to the RPS receptacle.
Before performing any of the following procedures, ensure that power is
Before working on a system that has an On/off switch, turn OFF the power and
This unit might have more than one power cord. To reduce the risk of electric
Connecting External Devices to the Cisco RPS
Connecting Cables 4-3