rps4 Page 10 Monday, September 14, 1998 8:19 AM
Connecting External Devices to the Cisco RPS
Connecting Switches
All the switches (Catalyst 1900 and Catalyst 2820 series switches and the Catalyst 2900
series XL switches) can use:
•
One-to-one cable for quasi-redundancy
•
One-to-one cable with the switch AC power cable connected for redundancy with
reboot
•
Two-to-one Y-cable for full redundancy
•
Two-to-one Y-cable with the switch AC power cable connected for redundancy with
reboot
Depending on when it was manufactured, a Catalyst 1900 series switch (WS-C1900,
Note
WS-C1912, or WS-C1900C) may need a special cable: CAB-RPS-2218A(=). For ordering
information, contact Cisco Customer Service at 800 553-6387 or 408 526-7209.
Follow these steps to connect switches to the Cisco RPS:
Step 1
Step 2
4-10
Cisco Redundant Power System Hardware Installation Guide
Power OFF the switch to which you will connect the Cisco RPS by
disconnecting the AC power cord.
Connect one end of the one-to-one cable or the Y-cable to the RPS connector on
the rear panel of the switch, as shown in Figure 4-8 through Figure 4-12.