Tools And Equipment Required - Cisco FastHub 100 series Installation Manual

rps2 Page 4 Monday, September 14, 1998 8:17 AM
Rack-Mounting the Cisco RPS
•
Baffles can isolate exhaust air from intake air, which also helps to draw cooling air
through the chassis. The best placement of the baffles depends on the airflow patterns in
the rack, which can be found by experimenting with different configurations.
•
When equipment installed in a rack (particularly in an enclosed rack) fails, try operating
the equipment by itself, if possible. Power off other equipment in the rack and in
adjacent racks to allow the unit under test a maximum of cooling air and clean power.
•
Install the Cisco RPS and the external device to which it will connect in adjacent shelves
in a rack.

Tools and Equipment Required

You need the following tools and equipment to rack-mount the Cisco RPS:
•
Number 2 Phillips screwdriver (not included)
•
Screws for attaching the Cisco RPS to the rack (not included)
•
Rack-mount brackets (see Figure 2-1 and Figure 2-2):
— One set of 19-inch brackets (ACS-3640RM-19=) ships with the Cisco RPS.
— Order 23- or 24-inch brackets (ACS-3640RM-24=) as needed.
— Order telco brackets (AS52/3RM-TELCO-19=) as needed.
2-4 Cisco Redundant Power System Hardware Installation Guide