Table of Contents
Advertisement
Loss of Signal
Setting
Static Control
Auto/Custom
Programs
This setting controls how the product will respond when the DMX signal is
lost.
1. Go to the SETTINGS > PERFORM level, and select DMX
ERROR.
a. Select SAVE to make the product use the last command used
when the signal is lost.
b. Select BLACK to turn off the all the LEDs when the signal is lost.
The Static Color mode allows for permanent RGBW color mixing without a
DMX controller.
1. Go to the MANUAL > MANUAL.
2. Select DIMMER.
a. Set the intensity value (000~255).
3. Select RED, GREEN, BLUE, or WHITE.
a. Select the color value (000~255).
b. Repeat for the other colors.
4. Select PAN or TILT.
a. Set the position value (000~255).
b. Repeat for the other position.
5. Select STROBE.
a. Set the frequency value (000~255).
6. Select ZOOM.
a. Set the angle value (000~255).
Auto programs allow for dynamic RGBW color mixing without a DMX
controller.
1. Go to STAND ALONE > RUN.
2. Select the desired auto (AUTO1, AUTO2), test (TEST), or
custom program (CUSTOM).
You cannot edit any of the auto or test programs (AUTO1, AUTO2, or
TEST).
Advertisement
Table of Contents
