Changing Channels - brace DWG 1000 User Manual

Changing Channels

DWG-1000 system components are linked at the factory. In the rare event that
the Link LEDs on both the Transmitter and Receiver units continue to blink and
fail to light solid, your DWG-1000 might be sharing channels with another
wireless system. The RF Mating feature enables you to switch to one of over
65,000 non-competing channels. To switch channels, use an unfolded paper
clip to depress the Function Buttons.
"Link LED"
Rx
1) Plug guitar cables into each unit to turn them on, (snicker) and place
the Rx and Tx units close to each other. (Don't stare. They're shy...)
2) On the Receiver unit (RX/Dark Green) press in the Function Button and
hold until the Link LED blinks rapidly. Release the button at this point. RF
mating has been initiated now on the RX unit.
3) On the Transmitter unit (Tx/Gray), press in the Function Button and hold
until the Link LED blinks rapidly. Release the button at this point. The TX
unit will now negotiate with the RX unit and a new random channel will be
assigned. When finished, both RX and TX LEDs will light solid indicating
that the units are now correctly working on the new channel.
To exit RF Mating mode, turn the units off (unplug the cables) and they will retain
their new mating ID; even after changing batteries. Future frequencies may vary
based on location, so tattoos are not advised, though flowers and breakfast in
bed would be a nice touch.
LINK LOW B
FN
Function
FN
"Link LED"
LINK LOW B
Tx
9