Configuring Multiple Transmitters - brace DWG 1000 User Manual

Configuring Multiple Transmitters
Up to 12 DWG-1000 TX transmitters can be associated, or bonded, to each
But it's only one Transmitter at a time!
receiver.
your entire rack of axes hooked-up and ready to go; live or in the studio.
!
Plug cables into
all units first!
1. Place Tx-1a close to the receiver. Push and hold the paperclip button on
transmitter unit 1a until the link LED blinks rapidly.
2. Place Tx-1b close to the receiver. Push and hold the paperclip button on
transmitter unit 1b until the link LED blinks rapidly.
3. Continue for all remaining transmitters you want to configure...
4. Push and hold the paperclip button on the single receiver unit until the link LED
blinks rapidly.
5. Wait until the link LED's go solid on all the units and then you are done.
All the transmit units are now bonded to the single receiver; even after they are
shut off. If you change batteries, they will still be bonded. The bonded channel
number is a random value of 1 - 65,536. This allows multiple band members to
bond their transmitters to their own receivers without worrying that there will be
a conflict on a band-mate's channel.
Please note: You cannot use more than one of the bonded transmitters at a
time. If you do, two (or more) bonded channels will collide with each other. Life -
as we know it - could come to and end, and it would be your fault. And future
authorities will find out who you were, because you registered your rig at
www.braceaudio.com. So, one axe at a time, please. The World thanks you...
Always unplug the transmitter(s) that you are NOT using,
10
Tx - 1c
You must press the Rx button last, or things won't work!
to prevent problems when switching to your next axe!
Tx - 1b Tx - 1a
This is very cool for having
etc...
Rx-1
Oh, grow up!