Table of Contents
Advertisement
Receiver
Receiver (Rx / Dark Green Unit)
1. Link LED
("LINK")
The LED lights solid when a
wireless connection is made
between the Tx and Rx units,
and pulses when finding a
connection to one of over
65,000 channels (!)
5. Jack for AC Adapter
Use only the Brace Audio supplied or
recommended power supply.
Approved replacement AC Adapters are listed at
www.braceaudio.com/Products
3V DC, 500mA Regulated AC Adapter
Polarity :Tip Positive (+)
Adapter size 2.3 mm outside diameter, 0.7 mm
inside diameter
6
2. Low Battery LED
("LOW B")
When the batteries are low
(less than 15 minutes of
battery life), the Low Battery
LED lights solid.
LINK LOW B
FN
3. Function Button
("FN")
Press the Function Button to
initiate Mating Function if
necessary. (see section,
Changing Channels). Use the
end of an unfolded paper clip to
access the button.
4. Audio Out Jack
Plug the 1/8" connector on the included
cable into the Audio Out Jack, and the 1/4"
connector into your amplifier. This jack also
acts as a switch, turning the unit on when
the plug is inserted. Unplug the cable to
turn the unit off. Before plugging the Rx into
your guitar amp, turn the amplifier volume
all the way down. This will prevent feedback
or unwanted pops.
("The Other Hole")
Advertisement
Table of Contents
