Low Battery Led; Changing Batteries; Ac Adapter - brace DWG 1000 User Manual

Low Battery LED

The low battery LED will turn on when the battery power is at a minimum,
indicating 15 minutes or less left of battery life. When this occurs, follow the
instructions under Changing Batteries.

Changing Batteries

To change batteries on either the Transmitter or Receiver, remove the cover
plate on the back of the unit. Press down at the top and slide the cover open.
Each unit takes two "AA"batteries. Be sure to observe the proper polarity of
the batteries.

AC Adapter

The DWG-1000 Receiver (Rx) can be operated with the supplied AC adapter
or two AA batteries. The provided AC adapter accepts input voltages from
110V - 220V. Connect the AC adapter's power cord to the Rx AC adapter
power input jack.
If you always intend to power the Rx from
8
the AC Adapter, remove the batteries.