Symptom
•
Unit will not power on.
•
No sound output from
speakers.
•
Noise/Distortion in sound
output.
•
Unit fails to respond.
•
Cannot listen to any
station, or signal appears
weak.
•
The sound is distorted.
•
CD stops immediately
after starting, or unit
pauses or stops during
play.
•
No sound.
•
CD playback is noisy, or
playback stops or skips.
•
CD tray will not open
•
Buttons are not
functioning correctly.
•
Decline in turntable audio
performance
•
No sound output with
external audio device
plugged into the AUX in
jack.
For further assistance with your product, call Innovative Technology at
TOLL FREE# 1‐877‐ITECH‐97 (1‐877‐483‐2497).
TROUBLESHOOTING GUIDE
Possible Cause
•
Unit is unplugged.
•
The volume level is set too low.
•
The input selector does not
match the playback source.
•
The unit is too close to a TV set or
other interfering device.
•
May result from external factors
such as ESD (Electro‐static
discharge).
•
The station is not tuned‐in
properly.
•
A TV set is being used nearby and
is interfering with the radio
reception.
•
The antenna is not oriented
properly.
•
The CD is inserted upside down.
•
The CD is dusty or dirty or there is
condensation on the CD.
•
The CD player is paused.
•
The CD is scratched, damaged or
warped.
•
The disc is very dirty.
•
CD mode is not selected.
•
The unit is processing information
("‐ ‐" is displayed).
•
The unit needs to be restarted.
•
The turntable stylus is worn out
•
The external audio source is
paused or off.
•
The sound is not loud enough or is
muted.
11
Solution
•
Connect the unit to the AC
power supply.
•
Adjust the volume.
•
Select the correct input
source.
•
Turn off the TV or other
appliance, and relocate the
unit.
•
Disconnect the power cord
and external audio device.
Re‐plug the power cord after
one minute.
•
Properly tune‐in the desired
station.
•
Turn‐off the interfering TV
set.
•
Re‐position the antenna until
reception improves.
•
Insert the CD with the
printed side right‐side up.
•
Carefully clean and dry the
CD.
•
Press the PLAY/PAUSE
button.
•
Replace CD with an
undamaged one.
•
Carefully clean the CD.
•
Select CD mode with the
FUNCTION knob.
•
Wait until the unit finished
processing.
•
Turn the unit off, then on
again.
•
Replace the stylus
•
Set the external audio source
to play or turn it on.
•
Adjust the volume level on
the external audio source or
un‐mute the external audio
source.