KERN ITB Operating Instruction page 20

Settings in the menu
20
Small platform model
1.Display "Scale":Press the
2.Display "Metrolo":Press the
3.Display "ramp":Press the
4.Display "SNR":Press the
5.Display "SCAL.bld":Press the
6.Display "GEO" (adjustment by means of GEO value):
The GEO value can be set in this block and the balance also adapted to the local grav-
ity ratios without adjusting weights.
Case a)You are familiar with the GEO values.
Once the -key has been pressed, the current GEO value will be displayed.
Press the or
played every time the key is pressed (adjustment range: 0 - 31). See the GEO value
chart in chapter 7.1.1 for the appropriate value.
Confirm the selected GEO value using the
Please note: The GEO value may not be readjusted following this "adjustment by
means of GEO value", as this would cause the set adjusting values to become invalid.
Case b)You are NOT familiar with the GEO values. In this case adjustment must be
made using adjusting weights (see item 8).
Press the -key.
7.Display "LIN-CAL:" Press the
8.Display "CAL:" Press the
Press the -key. The scale determines the zero point. -preload- appears in the dis-
play. The calibration weight to be placed on the scale then flashes in the display.
If necessary, change the weight value displayed with
Place the calibration weight on the scale and confirm with
The scale calibrates with the calibration weight loaded. After calibration is completed,
-done- appeats briefly in the display.
-key (within 20sec)
-key
-key
-key
-key
-key, in order to alter the GEO value. . The next value is dis-
-key.
-key.
Large platform model
-key.
User manual ME-Nr. 22017071 01/07
ITB-BA-e-0720