CyberScout User Manual
7)
Let go of the camera shroud, and keep hands and tools away from
it until the unit stops moving (about three seconds). It is initializing.
To change the standalone operation settings:
1)
While the camera is moving, grab the camera shroud and turn it so
you can access the DIP switch.
CAUTION:
After the last DIP switch is reset in the steps below, do not interrupt
the movement of the camera. It is initializing. Wait for the camera to
stop moving (about three seconds).
2)
Reset the switches to the new autopan settings. See Figure 41 and
Figure 42.
3)
Let go of the camera shroud, and keep hands and tools away from
it until the unit stops moving (about three seconds). It is initializing.
Figure 41. Tilt positions
1038864A / December 2002
Near vertical
Operating the CyberScout
Horizontal
37