CyberScout User Manual
2.8
CONNECTING THE TEMPORARY VIDEO OUTPUT
The video output connector (
output connection for a pocket (or other) monitor. Use this connection
during installation to adjust the camera.
1)
Locate the video output connector (
through the side of the camera shroud (
2)
Insert the 2-pin plug of the video output cable (
the video output connector.
Note: The 2-pin plug and receptacle are keyed. The plug must be completely
pushed into the receptacle to transmit video.
3)
Attach the video output cable to a monitor.
4)
Proceed to section 2.13 Adjusting the Camera.
5)
After the camera is adjusted, remove the video output cable.
Camera shroud
Video output cable
Video output connector
Figure 25. Connecting the temporary video output
1038864A / December 2002
in Figure 25) provides a temporary video
in Figure 25) that protrudes
Installing the CyberScout
in Figure 25).
in Figure 25) into
27