Table of Contents
Advertisement
Installing the CyberScout
3)
Pull the video, power, and control cables out of the mounting
surface and prepare the cables (as shown). They will connect to an
interface module in later steps.
Figure 13. Preparing the cables
CAUTION:
For safety, the hardware and procedure used for securing the
adapter must enable it to support at least 35 pounds (15.88 kg).
CAUTION:
To ensure the proper operation of the camera, mount the unit level.
See Figure 14 and perform the following:
4)
Install the mounting
hardware from which
you'll hang the wall-mount
adapter.
5)
Pull the video, power, and
control cables through the
adapter's cable entry
hole.
6)
Slide the adapter down
onto the mounting
hardware.
7)
Ensure that the adapter is
level.
8)
Seal all mounting holes
that could cause leaks
into the mounting surface.
16
Video (terminate with BNC connector)
RS422 control (strip wire ends)
24 VAC power (strip wire ends)
Figure 14. Installing the wall-mount adapter
1038864A / December 2002
CyberScout User Manual
Advertisement
Table of Contents
