Table of Contents
Advertisement
Operating the CyberScout
3.2
S
TANDALONE
CyberScouts can be operated without a keypad as standalone cameras
in a fixed autopan mode. The DIP switches are used to control the speed
and pan/tilt positions of CyberScouts operating as standalone units. See
Figure 40. (The DIP switches are not needed for site addressing when
the CyberScouts are being operated as standalone units.)
Left pan limit
Figure 40. Standalone DIP switches
To program standalone operation:
1)
Remove the dome. Refer to section 2.9.2 Attaching the Dome and
reverse the procedure given.
2)
Find the DIP switch. It protrudes through the side of the camera
shroud.
CAUTION:
After the last DIP switch is reset in the steps below, do not interrupt
the movement of the camera. It is initializing. Wait for the camera to
stop moving (about three seconds).
3)
Refer to Figure 41 and Figure 42 to find your desired tilt and pan
autopan settings.
4)
Set the switches that correspond to those autopan settings.
5)
Set the pan speed by setting switch 10 to ON for fast or OFF for
slow.
6)
Set switch 11 (operating mode switch) to ON for standalone
operation. See Figure 40.
36
O
PERATION
Right pan limit
CyberScout User Manual
Pan
Tilt
speed
1038864A / December 2002
Operat-
ing
Not
mode
used
Advertisement
Table of Contents
