Table of Contents
Advertisement
CyberScout User Manual
3
O
PERATING THE
You can operate your CyberScout in normal mode with a keypad or in
standalone mode with its DIP switch. See sections 3.1 Keypad Operation
and 3.2 Standalone Operation.
CAUTION:
To ensure that units are operating properly, test the pan, tilt, and
lens functions once each week.
3.1
K
EYPAD
You can program and operate autopan limits and presets from any
Kalatel keypad. Refer to your keypad's manual for instructions.
Programming of ShadowTours and recalibrating are accomplished
differently per keypad. See Table 2.
Note: The CyberScout has 64 presets (0 – 63).
Table 2. Keypad-specific CyberScout functions
Function
ShadowTour
Recalibration
3.1.1
P
ROGRAMMING
Two macros must be programmed into the KTD-404 keypad for the
CyberScout. One is used to program a ShadowTour and the other is
used to recalibrate the CyberScout.
Note: CyberScouts should not be recalibrated unless it is necessary. Refer to section
4 Troubleshooting to learn when to recalibrate your CyberScout.
1038864A / December 2002
C
O
PERATION
KTD-400
Programming not
available, but
operation available.
Refer to your
keypad's manual.
Not available
C
S
YBER
COUT
S
YBER
COUT
Keypad
KTD-404
Requires a macro.
See section 3.1.1
Programming a
Macro.
Requires a macro.
See section 3.1.1
Programming a
Macro.
M
ACROS INTO THE
Operating the CyberScout
KTD-405
Request new
Not
firmware for
available
keypad.
Request new
Not
firmware for
available
keypad.
KTD-404 K
CBR-
KB3/J
EYPAD
31
Advertisement
Table of Contents
