Assembly - Gardena AccuCut 400 Li Operating Instructions Manual

Only charge battery between 10 – 45 °C. After
heavy duty service allow battery to cool down
first.

3. Assembly

Assembling the trimmer :
2
1
Fit magazine for
spare blades :
4
Fit additional wheel :
8
14
1. Push the cover
2
behind
3
2. Push plant guard
until it locks into place.
20 plastic blades and a magazine for spare blades are supplied
with your trimmer. Up to 6 spare blades can be stored in the
magazine.
5
1. Slightly widen magazine
6
5
handle
2. Insert up to 6 plastic blades
blades jam.
To fit blade into blade carrier see 8. Troubleshooting
"Replacing blades" .
The additional wheel is available as an optional extra for the
AccuCut 400 Li. The additional wheel is already fitted on the
AccuCut 450 Li.
Fit additional wheel :
v Fit additional wheel
guides of the handle holder
until you hear the connection
lock into place on both sides.
z
T
Remove additional wheel :
v Pull both catches
side and remove the additional
7
wheel
handle holder
Fold additional wheel up / down :
v Press adjusting buttons
7
sides, fold additional wheel up / down
and release the adjustment buttons
Storage :
The trimmer must not be stored over 35 °C or
under direct exposure to sunlight.
Do not store the trimmer in places with static
electricity.
3
into the guide of the cutting head from
until the connection locks into place on both sides.
1
onto the cutting head from the front
4
at open point and slide onto
.
6
in the magazine
7
onto the
8
9
out to the
from the guides of the
8
.
z
on both
T
2
4
until the
9
7
7
z
again.
T