Table of Contents
Advertisement
4. OPERATING AND PROGRAMMING THE SM40 SURVEILLANCE CENTRE
SM40 SURVEILLANCE INSTALLER PROGRAMMING MENU
Status / Action
The display shows the following:
Pressing '0' will display:
The display if the memory was not cleared.
4
22
Result / Remarks
*INSTALL MENU*
PRESS 'C' TO CLEAR ALL MEMORY
Because this program clears the complete memory, caution must be taken. The
display after pressing 'C' is as follows:
CLEAR ALL MEMORY: ARE YOU SURE ?
'0' CLEARS; ANY OTHER KEY ABORTS
Pressing any key except '0' will return to the main menu
* * * WARNING * * * MEMORY CLEARED
After 3 seconds the following message is displayed
* * * SYSTEM MUST BE PROGRAMMED * * *
* * * GO TO INSTALLER MENU * * *
The system is now no longer in the programming mode.
*INSTALL MENU*
PRESS 'BREAK' TO EXIT PROGRAMMING MODE
Pressing 'Break' now will return to the normal scan mode.
Scroll with 'ENTER'
Scroll with 'ENTER'
Advertisement
Table of Contents
