Table of Contents
Advertisement
4. OPERATING AND PROGRAMMING THE SM40 SURVEILLANCE CENTRE
SM40 SURVEILLANCE INSTALLER PROGRAMMING MENU
Status / Action
After pressing '6' the display shows:
When ready the display will show:
Display after pressing 'Enter':
Display after pressing '7':
Display after input of zone number (1-32)
and after pressing 'Enter'.
Display after input of zone number (1-128)
and after pressing 'Enter'.
Display after pressing '0', if the selected unit
was present.
Display after pressing '1', if the selected unit
was present.
Display if the selected unit was NOT present.
Result / Remarks
SCANNING ZONE:XX
All the relevant zones will be scanned and the units present will be stored in
memory.
TOTAL SYSTEM SCAN TIME: XX MIN XX SEC
Press 'ENTER' to continue . . . .
This is the time interval between two scans of the same unit. This information is
relevant for 'priority scanning'' programming.
*INSTALL MENU*
PRESS '7' TO ADD/DELETE UNITS
This program is used to manually add or delete surveillance units.
ENTER ZONE NUMBER:
ZONE: XX
ENTER UNIT NUMBER
ZONE: XX UNIT: XXX
PRESS '0' TO DELETE; '1' TO ADD
ZONE: XX UNIT: XXX
PRESS '7' TO ADD/DELETE UNITS
ZONE: XX UNIT: XXX
PRESS '7' TO ADD/DELETE UNITS
ZONE: XX UNIT: XXX
ENTER UNIT NUMBER
At this stage in the programming a new unit number may be entered, and the
proces repeated.
Pressing 'Break' will return to 'ENTER ZONE NUMBER'.
Pressing 'Break' again will return to the main menu.
UNIT:XXX
Scroll with 'ENTER'
DELETED
ADDED
NOT FOUND
4
19
Advertisement
Table of Contents
