Table of Contents
Advertisement
4. OPERATING AND PROGRAMMING THE SM40 SURVEILLANCE CENTRE
4.3.2
SM40 SURVEILLANCE INSTALLER PROGRAMMING MENU
Status / Action
To enter the INSTALLER programming
mode, press keys '8', '1', followed by the
'Enter' key. Ther display shows:
Display if system is installed:
Display after pressing '4'.
4
After pressing '5' the display shows:
Display after pressing 'Enter'.
Display after pressing 'Enter'.
Display after pressing 'Enter'.
18
Result / Remarks
> WELCOME TO SURVEILLANCE PROGRAMMING <
>> VERSION X:XX
The 'welcome' display shows the current software version and its release date. After
three seconds this message is cleared and the first programming mode is displayed.
Programs 1, 2 and 3 are identical to that of the User Programming. In the 'installer
mode' the first display is as follows:
*INSTALL MENU*
PRESS '4' TO STORE SYSTEM HARDWARE
To enable the system to operate correctly, the current hardware configuration must
be stored. This is done by pressing key '4'.
*INSTALL MENU*
STORING HARDWARE CONFIGURATION
The display is only shown during storing, then continues as follows:
*INSTALL MENU*
PRESS '5' TO DISPLAY SYSTEM SETUP
SWITCH CARDS: XX XX XX XX
RELAY CARDS I: XX XX XX XX
II: XX XX XX XX
I/O BOARD MOUNTED: YES
*INSTALL MENU*
PRESS '6' FOR AUTO-STORE OF ALL UNITS
This program stores all the loudspeaker/amplifier surveillance boards which are
present in the system's memory. However a zone will only be scanned if:
- The corresponding surveillance switch card is present.
- The unit with adddress '1' is connected to that zone and recognised.
DATE DD-MM-YY <<
Scroll with 'ENTER'
Scroll with 'ENTER'
Scroll with 'ENTER'
Scroll with 'ENTER'
Advertisement
Table of Contents
