Table of Contents
Advertisement
4. OPERATING AND PROGRAMMING THE SM40 SURVEILLANCE CENTRE
SM40 SURVEILLANCE INSTALLER PROGRAMMING MENU
Status / Action
The display shows the following:
Display after pressing '8'.
Display after pressing '2'.
Display after input of zone number (1-32)
and after pressing 'Enter'.
4
Display after pressing '9'.
Display after pressing '1'.
Display after input of zone '1' or '2' and
'Enter'.
20
Result / Remarks
*INSTALL MENU*
PRESS '8' TO SHOW ALL UNITS
DISPLAY OF ALL UNITS FOUND
PRESS '1' FOR PRINTER; '2' FOR DISPLAY
Pressing '1' will send a list of stored units (zone-by-zone) to the printer.
The header will show date and time.
ENTER ZONE NUMBER: XX
ZONE: XX UNITS CONNECTED
XXX XXX XXX XXX XXX XXX XXX XXX XXX XXX
Pressing 'Enter' will show the next 10 units. Pressing 'Break' will repeat zone input
request, pressing 'Break' again will return to main menu. The display will show:
*INSTALL MENU*
PRESS '9' TO SET PRIORITY SCANNING
This program cause the scanning sequence to be interrupted, while zone 1 or 2
(or both) are scanned at a programmed time interval
PRIORITY SCANNING
PRESS '0' TO DISABLE; '1' TO ENABLE
Pressing '0' will disable priority scanning and return to main menu.
PRIORITY SCAN OF ZONE (1 OR 2):
PRIORITY SCAN OF ZONE (1 OR 2):X
ENTER INTERVAL TIME (O-9 MIN.):
Input of '0' minutes will disable priority scanning for that zone. Input of any other
time (1-9 minutes) will cause an extra scan of that zone to occur at the
programmed time interval. The current zone scan however will finish first.
Scroll with 'ENTER'
Scroll with 'ENTER'
Advertisement
Table of Contents
