Table of Contents
Advertisement
4. OPERATING AND PROGRAMMING THE SM40 SURVEILLANCE CENTRE
4.3
SM40 USER PROGRAMMING
4.3.1
SM40 SURVEILLANCE USER PROGRAMMING
Status / Action
When the system is 'powered up', one of the
next two displays is shown:
The first display shows when the memory has
been cleared. The system is inoperative until
installed (via the Installer menu).
The second display shows when the system is
installed.
To enter the user programming mode, press
keys '9', '6', followed by the 'Enter' key. The
display shows:
4
Display after pressing '1'.
Display after selection:
16
Specific contexts (status) and user actions are shown in the left column, and possible display results are
shown in the right column. Characters between quotes (e.g. 'Key') denote keyboard inputs, and occurrances
of
XX
and
YY
in any displays shown in the right column denote information which is dependant on the
system configuration, or entered by the user.
Unless stated otherwise, 'Enter' stores typed information in the memory. 'Break' aborts a command without
storing new information.
Result / Remarks
The 'welcome' display shows the current software version and its release date. After
three seconds this message is cleared and the first programming mode is displayed.
The first programming mode is displayed as follows:
*USER MENU*
PRESS '1' TO SELECT ERROR PRINTING
DISPLAY OF ERRORS ON PRINTER
PRESS '0' TO DISABLE; '1' TO ENABLE
The current selection will be displayed. Selecting '0' will show all errors displayed
on the lower line. Selecting '1' will send all errors to the printer, with the lower line
showing the current date and time
*USER MENU*
PRESS '2' TO PRINT CURRENT ERRORS
Pressing '2' will produce a printout of loudspeaker, external, and system errors
(regardless of the settings in user menu '1' shown above). The header will show the
date and time.
This function is useful for incidental printing, when no permanent printer is
connected. If the printer is not powered, off-line, or the serial board parameters are
not correctly programmed (via the installer program), the display will show (see
next page):
* * * SYSTEM MUST BE PROGRAMMED * * *
* * * GO TO INSTALLER MENU * * *
* * * SM40 SURVEILLANCE SYSTEM * * *
DATE:XX-XX
> WELCOME TO SURVEILLANCE PROGRAMMING <
>> VERSION X.X
TIME:XX:XX
DATE XX-XX-XX <<
Scroll with 'ENTER'
Scroll with 'ENTER'
Advertisement
Table of Contents
