Table of Contents
Advertisement
4. OPERATING AND PROGRAMMING THE SM40 SURVEILLANCE CENTRE
4.2.1
Display readout
Status / Action
When memory was cleared the display shows:
When the system was installed previously,
the display shows:
This message will disappear after 2-seconds,
and the system will start scanning.
When scanning and error printing are enabled
(refer to User Programming Menu) the
display shows:
The second display line is used to display the
current date and time.
When scanning and error printing are
disabled (refer to User Programming Menu)
the display shows:
The second display line is used to display
errors. Errors are indicated one by one in a
4
continuous cycle.
Loudspeaker/amplifier errors are displayed as
follows:
External errors are displayed as follows:
System errors are displayed as follows:
14
During the remainder of this chapter, specific contexts (status) and user actions are shown in the left
column, and possible display results are shown in the right column. Characters between quotes (e.g. 'Key')
denote keyboard inputs, and occurrances of
information which is dependant on the system configuration, or entered by the user.
When the SM40 system is powered up, either one of the following two displays is shown:
Result / Remarks
SCANNING ZONE: XX UNIT XX
DATE: XX-XX
SCANNING ZONE: XX UNIT: XXX
SCANNING ZONE: XX UNIT: XXX
ERROR IN ZONE: XX UNIT: XXX
SCANNING ZONE: XX UNIT: XXX
<ERROR> EXTERNAL INPUT: XX
SCANNING ZONE: XX UNIT: XXX
<ERROR> SWITCH CARD: XX
SCANNING ZONE: XX UNIT: XXX
<ERROR> RELAY CARD: I-XX
SCANNING ZONE: XX UNIT: XXX
<ERROR> RELAY CARD: II-XX
XX
and
YY
in any displays shown in the right column denote
* * * SYSTEM MUST BE PROGRAMMED * * *
* * *
GO TO INSTALLER MENU
* * * SM40 SURVEILLANCE SYSTEM * * *
DATE:XX-XX
* * *
TIME:XX:XX
TIME: XX:XX
Advertisement
Table of Contents
