Harris Atlas DVL400 Technical Manual page 95

ATLAS Series™
STEP 2
STEP 3
STEP 4
NOTE:
The procedure can be aborted by pressing any of the 5 hardware Quick keys
on the control panel.
(a)
(a)
Figure 3-41 Touchscreen Calibration Test Screen
2/25/03
WARNING: Disconnect primary power prior to servicing.
Once you see the screen in Figure 3-40, simply touch the X in the
first 2 screens. This will get you to the first screen in Figure 3-41.
To test the calibration simply touch the screen in several places to
make sure an X shows up where you touched.
If the calibration is good, then press ACCEPT. If not, press
CANCEL and the cal procedure will be started over.
Figure 3-40 Touchscreen Calibration Screens
888-2473-001
Section 3 Operation
(b)
(b)
3-35