Harris Atlas DVL400 Technical Manual page 65

ATLAS Series™
There are always five touchscreen navigation buttons on the right side of the
display. These are different on almost every screen and, with the exception of the
HOME screen, do not relate to the hardware buttons on the front panel just to the
right of the display. These can also act as status indicators and turn red if a fault
condition is detected.
For multiple cabinet transmitters, there is also a navigation button
(shown to the right) for the second PA cabinet to allow access to
information specific to that cabinet. Pressing either of these buttons
will take you to the Power Amp screen shown in Figure 3-12 on page
3-13 for the desired cabinet.
This button is also a metering and status indicator for each PA cabinet
as it shows forward power (before the filter) and will change from OK
to Fault, if a problem is detected in that cabinet as shown to the right.
NOTE:
To simplify the discussion of GUI navigation, the following will navigate and
describe all of the screens under each of the 5 main menu buttons located to
the right of the touchscreen display (and on the right side of the GUI Home
page).
2/25/03
WARNING: Disconnect primary power prior to servicing.
888-2473-001
Section 3 Operation
3-5