1. Manuals
  2. Brands
  3. Interquartz Manuals
  4. Telephone
  5. E2
  6. User manual

Interquartz E2 User Manual

Electronic telephone
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
A583-67.pm6
1
FEATURES ........................................................................................................... 4
IMPORTANT NOTES ............................................................................................ 5
SETTING UP ......................................................................................................... 6
Installation
GENERAL CONTROLS AND INDICATORS ........................................................ 13
SPECIAL FUNCTIONS ......................................................................................... 16
3C583011-XA03B
Size : 204 mm (H) x 157 mm (W)
4/9/99, AM 10:11
CONTENTS
1
A583-67.PM5
Page 11 / 40 Sheets

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E2 and is the answer not in the manual?

Questions and answers

Related Manuals for Interquartz E2

Summary of Contents for Interquartz E2

  • Page 1: Table Of Contents

    Wall Mounting Wall-mount bracket ( Optional not included with phone ) GENERAL CONTROLS AND INDICATORS ............13 Handsfree Button ( E3 only ) On Hook Dial Button ( E2 only ) Mute Button Store Button Redial Button Clock/Time and Start/Stop Buttons...
  • Page 2 Backspace Button ( < Pause Button & Automatic Pause Insertion WARRANTY ......................36 EEprom Memory Feature SERVICE CENTRES ..................... 36 E3/E2 QUICK REFERENCE GUIDE ..............18 GLOSSARY ......................37 OPERATION-OUTGOING CALL ................27 Handset Operation Handsfree and On Hook Dial Operation...

  • Page 3: Features

    * Direct Redial feature allows the re-try of a busy number This Interquartz telephone is approved for use on private branch exchange * On Hook dialling operation (E2) or Handsfree operation (E3) with speaker extensions, business or private direct exchange lines. The Austel approval volume control label is located on the telephone.

  • Page 4: Setting Up

    2. enter the hour, eg. 5, * operating manual, 3. enter the minutes (must be two digits), eg. 09, * batteries ( 2 for E2, 4 for E3 ). 4. if AM, enter 0, 5. if PM, enter 1, INSTALLATION 6.

  • Page 5: Technical Adjustments - For Correct Operation

    FLASH TIMING FLASH TIMING SELECTORS - SELECTORS - TECHNICAL ADJUSTMENTS - FOR CORRECT SWITCH B (SEE TABLE 1) SWITCH A (SEE TABLE 1) OPERATION CAUTION : Please exercise care when adjusting all selectors described, as they and their surrounding electronic components may be damaged by rough treatment. It is also recommended that all adjustments be made with the telephone disconnected from the line.

  • Page 6: Location

    HANDSET RETAINER WALL-MOUNT BRACKET (Optional not included with phone) NOTE : The WALL MOUNT BRACKET and MODULAR WALL JACK illustrated are available from your authorised Interquartz dealer. FIGURE 3 3. Insert the HANDSET 4. HANDSET RETAINER RETAINER for wall...

  • Page 7: General Controls And Indicators

    WAITING LIGHT CARD COVER PLATE USED FOR MODEL IQTEL 25 INSERT MEMORY HANDSET CORD CARD COVER LUG "C" ON HOOK DIAL VOLUME (E2) HANDSFREE VOLUME (E3) LUG "D" MOUNTING HOLE "F" BACKSPACE ON HOOK DIAL BUTTON (E2) MUTE BUTTON HANDSFREE...

  • Page 8: Handsfree Button ( E3 Only )

    This feature is storable in memory. press START/STOP, to restart it press START/STOP again. ON HOOK DIAL button ( E2 only ) RINGER INDICATOR / MESSAGE WAITING LIGHT Used to monitor an outgoing call. In this mode you may dial and listen to the call's Flashes when the telephone rings with an incoming call.

  • Page 9: Special Functions

    2 of the following storage procedure, activates the MONITOR SPEAKER condition is active. Press MUTE again to release the mute condition. (both E2 and E3) during dialling so that you can start a call just by pressing the memory button after it is programmed. To speak, remember to press HANDSFREE (if you have the E3) or lift the HANDSET.

  • Page 10: E3/E2 Quick Reference Guide

    E3 / E2 QUICK REFERENCE GUIDE This is storeable and appears on the display as an h. When stored in front of a number it gets a telephone line and star ts dialling. When stored at the end of the number if desired, it A 16-Digit liquid Crystal releases the line.
  • Page 11 2. if you want speed-dialling, press HANDSFREE (ON HOOK DIAL FOR Used for both manual and memory dialling. Pressing the PAUSE button will E2) which becomes "H" on the display, or ON/OFF HOOK (becomes "h" on cause the telephone to delay all following dialling functions for 2.5 seconds the display), after which further dialling may commence.
  • Page 12 Dialling procedure : 1. Iift HANDSET or press HANDSFREE, 2. press MEMORY once, and listen for confidence BEEP, An E2 or E3 can be fitted on request with an Electrically-Eraseable 3. telephone dials 0, waits for 2.5 seconds, then dials 457 5000.
  • Page 13 Memories. It should be used 3) shows on display as letter "H" (upper case). if the system requires it.Available range is 900 to 8000 4) equivalent to the use of the Handsfree (E3)/On Hook Dial (E2) milliseconds. button when storing Memories manually.

  • Page 14: Operation-Outgoing Call

    The ONE TOUCH Memory activates the PROMPT immediately above it's button, or you may lift the handset, if you are using the E2, lift the handset when you wish to start your and the TWO TOUCH Memory deactivates it. If matching opposite code-sets are...

  • Page 15: Redial Button

    " h " appears on the display before the number it will dial immediately, if the number is not preceded by " h " or " H " on the display, you can either press HANDSFREE or lift ( ON HOOK DIAL FOR E2 ) or lift the HANDSET to start dialling, 3.

  • Page 16: Handsfree Feature Operation

    HINTS FOR HANDSFREE OPERATION HANDSFREE FEATURE OPERATION (E3) As a courtesy, tell the other party that you are using the Handsfree function. He / She may or may not want people other than yourself to hear the conversation. As an alternative to the HANDSET, this feature allows you to conduct a A quiet environment ensures best Handsfree performance.

  • Page 17: Easycall And Customnet Usage

    If in doubt, check with your system supplier or some degradation of the telephone's performance may otherwise result. Interquartz dealer, as failure to observe your system's requirements may lead to difficulty in making outgoing external calls. If you have determined that a...

  • Page 18: General Care And Maintenance

    If the telephone service then operates satisfactorily, the fault is in the "suspect" telephone. * Test the "suspect" telephone on a known good line. If the fault still occurs the fault is the "suspect" telephone. Consult your Interquartz dealer for further advice if necessary. A583-67.pm6 34-35 4/9/99, AM 10:11...

  • Page 19: Glossary

    2-way conversation. or implied by the Trade Practices Act or other Commonwealth or State laws and all other obligations and liabilities on the part of Interquartz (A'Asis) Pty. HANDSFREE The mode of operation which allows a 2-way telephone Limited.

  • Page 20: User Manual

    USER MANUAL electronic telephone MODELS E2 & E3 Manufactured by International Quartz Limited A Subsidiary of Chiaphua Industries Ltd. by INTERQUARTZ BUSINESS PHONES 3C583011-XA03B ©Copyright INTERNATIONAL QUARTZ LTD. 1998 A583-67.pm6 38-39 4/9/99, AM 10:11...

This manual is also suitable for:

E3

Table of Contents