System Settings - Bosch DVR4C Installation Manual

DVR4x4Instal.book Page 16 Tuesday, February 15, 2005 9:25 AM
DVR4C | Installation Manual | Menu system
4.6 System Settings >
Use the System Settings menu to get access to those
items that are used to configure the system.
>> LANGUAGE
• A language is selectable from the list with the up/
down scroll keys. Press the play key to confirm.
>> AUDIO
• An audio input can be set to record with its
corresponding video input. Audio 1 is mapped to
video 1, audio 2 to video 2, audio 3 to video 3 and
audio 4 to video 4.
• For a Quad screen display in live mode, the 4 audio
channels are mixed. For a Quad screen display in
playback mode, no audio is played back. Audio is
only played back in forward, real-time and full
screen playback.
• Audio monitoring, recording and gain can be
configured per profile for each channel in the table.
>> TEXT
• The DVR can record and display ASCII data on the
monitor. The external device can be a text input
device.
>>> RECORDING
• Set On to record text data on the hard disk of the
DVR. Text is recorded separately from images,
but is synchronized based on time information.
Bosch Security Systems
>>> MONITORING
• Set On to display live text data on a monitor. Text
is overlayed on the live image.
>>> SYNC TEXT WITH
• Select All to display (and record) text data on all
channels (in a quad screen display, text appears in
the upper-left channel.) Text can also be displayed
(and recorded) with a specific channel only.
>>> SEEK HEADER
• If the text device sends a header, set to On.
• If a header is sent, select a single or a double line
header.
>>> DELIMITER
• If the text device sends an end-of-line delimiter,
enter its value.
>>> TIMEOUT
• If the text device does not send a delimiter, the
text is recorded as a single block. Enter the time
(in milliseconds) that must expire after the last
received character to separate text blocks.
>>> LINES
• If the text device does not send a delimiter or use
a timeout, enter the number of lines to be used
for a single block of text.
>> CONNECTIVITY
The Connectivity menu gives access to settings that
control the behavior of the unit with respect to all
external devices or a network.
>>> NETWORK
• Select the type of connection; Ethernet or xDSL.
• Set DHCP to On to have IP address, subnet mask
and default gateway assigned automatically by the
network DHCP server.
EN | 16