Recording; Event Setup - Bosch DVR4C Installation Manual

DVR4x4Instal.book Page 15 Tuesday, February 15, 2005 9:25 AM
DVR4C | Installation Manual | Menu system
4.4 Recording >
The overall schedule consists of 4 periods: Weekday
Day, Weekday Night, Weekend Day and Weekend
Night. The start and end time of each period is set in
the Profiles menu. Recording conditions can be
configured for each of the four periods.
>> RECORDING
• Set the normal recording rate and quality to be used
for all cameras.
• Set the recording rate and quality that are used when
an input alarm is triggered. All cameras then record
at these values when an input alarm is triggered.
• For each camera separately, set the conditions for

recording:

• Always - camera is always recorded at the set
recording rate and quality.
• Motion only - camera is recorded at the normal
rate and quality only when motion is detected (no
images are recorded when there is no motion).
• Motion + auto snapshot - camera is recorded at
the normal rate and quality when motion is
detected. The rest of the time a snapshot of the
camera picture is recorded (I-frame images only).
• Event Recording time can be configured to a
maximum of 120 seconds or to follow the event
duration.
• Pre-event recording time can be configured to a
maximum of 30 seconds. Pre-event recording takes
place:
a. on an alarm input if the normal recording rate is
0 IPS,
b. on a motion event (if a motion mode is selected).
Bosch Security Systems
4.5 Event Setup >
• The sensitivity of the motion detection has three
levels, Low, Medium and High or set to Off for no
detection.
• To setup the motion detect area for the whole screen,
select Select All.
• To clear the existing motion detect area setting, select
Clear All.
• To edit the motion area, select Custom Area. A
16x12 grid is displayed on the monitor. With the
scroll keys, move around the grid. Press the play key
to select a specific area. A blue square indicates a
selected area. To unselect a selected area, move on to
it and press the play key. When area selection is
completed, press ESC to close the area selection
mode. When motion is detected in a selected square,
it turns red.
Four different alarm inputs (Input 1, Input 2,
•
Input 3, Input 4) can be connected. Each alarm
input can be configured On (default) or Off. An
activated input alarm starts alarm recording on all
cameras.
EN | 15