Table of Contents
Advertisement
Divar - Easy | Installation Manual | Menu system
S
S
>
YSTEM
ETTINGS
Use the System Settings menu to get access to those items that are used to
configure the system.
MAIN MENU
SYSTEM SETTINGS
LANGUAGE
QUICK INSTALL
RECORDING SETUP
EVENT SETUP
HISTORY LOG SETUP
LOCAL PASSWORDS
CONNECTIVITY
FACTORY DEFAULTS
•
Select the language for the menu from the list.
•
Select Quick Install to quickly set up the system. The quick install menu
is described in Chapter 2.
•
If you select Factory Defaults, all settings in the menu system are reset to
their default value.
>> RECORDING SETUP
•
The continuous mode overwrites older recordings when the disk is full.
•
Set the period (None to 99 days) that recorded video is retained before it
is automatically deleted. Selecting None disables this feature. If you have
a small disk, the video might be overwritten earlier than the selected
video-delete period. This feature does not protect video from deletion.
>> EVENT SETUP
Use the Event Setup menu to specify the display behavior for an input, detected
motion or video loss.
•
Set the Alarm Dwell Time to select the period during which the output
relay and the beeper remain active after activation.
•
Set the Trigger Dwell Time to select the period during which the
triggered view mode is displayed after activation.
Bosch Security Systems
ENGLISH
>
>
>
>
>
>
•
The value Follows activates the beeper and relay or view, only as long as
the event is present.
>>> Input Setup
•
Enable the beeper to activate it when an alarm input is activated.
>>> Motion Setup
•
Using motion detection outdoors may cause false alarms because of
varying light conditions.
•
To restore the default motion settings select the Clear Motion
Settings item.
Motion area
•
Select a camera number.
•
The motion indicator shows the maximum level of camera motion
that has been detected for the defined area. Press F2 to clear it if
you want to re-test the level of motion detection.
•
Use the arrow keys to adjust the Trigger level slider to just below
the indicated motion level.
•
A motion detection signal is generated when the level of motion
reaches the trigger level set.
Edit area
•
Select Motion Area to define the picture area where motion is
detected.
•
Use the arrow keys to move around the grid. Press F1 to insert a
motion detection area and use the arrow keys to enlarge it. Press F1
again to save the area. Press the escape key to cancel and return to
grid square selection.
•
Press the select key to leave the grid. F2 clears all motion detection
areas.
>>> Video loss Setup
•
Select the monitor on which the camera with the video loss is
displayed.
•
Enable the beeper to activate it when any video loss occurs.
EN | 5-8
Advertisement
Table of Contents
