Bosch DVR4C Installation Manual page 17

DVR4x4Instal.book Page 19 Tuesday, February 15, 2005 9:25 AM
DVR4C | Installation Manual | Menu system
>>> REMOTE USERS
• Login names and passwords for the remote users
(4) and administrator can be specified here.
• The administrator login name is always "admin"
and cannot be changed.
• The remote user login name can be upto 16
characters long. The remote user password can
be up to 12 characters long.
• Access to playback (PB) and relay control (RL) is
set for each remote user by placing a Y (allowed)
or a N (not allowed).
• Even if remote relay is enabled, relays 1 and 2
cannot be controlled via the remote software as
they are already used for input alarms, motion
and system failures.
• Set Remote Setup to Enable (default) or Disable.
When set to Disable, configuration is possible
only via the front panel. PC users cannot
configure the DVR with the remote configuration
software. When set to Enable, both local and
remote users can configure the DVR.
• Set IP Filtering to On to restrict access to the IP
address list set up by the Configuration Tool
application.
>> TIME SYNC
This setting is used for time synchronization over the
network. DVRs can be synchronized by setting them up
as a client for an SNTP server. The DVR can also be set
up to act as a local time server, when it is configured in
SNTP server mode.
Bosch Security Systems
>>> NETWORK TIME SERVER
• Select On to allow the DVR to synchronize time
either as a client or as a master.
>>> SERVICE MODE
• Select Client to allow the DVR time setting to be
synchronized by a network time server.
• Select Master to allow the DVR to act as a
network time server and send its time to other
DVRs to synchronize them.
>>> SERVER IP ADDRESS
• Enter the IP address of the network time server.
• This network time server can be either a different
DVR, a computer or a server in the network. The
time is checked and synchronized with the
network time server once every hour.
>>> SYNCHRONIZE
• When this button is pressed, the time is
synchronized with the network time server and
other DVRs immediately.
>> BEEPER
Select whether the beeper should sound when videoloss
is detected or an input alarm is activated. Select On
(default) or Off. When an input alarm or videoloss
occurs, it sounds for as long as the specified relay dwell
time.
EN | 19