Accessories And Options; Approvals And Conformities - AEG THYRO-A Operating Instructions Manual

➜

12. Accessories and options

Order no. 8000 006 763 Support for 35mm snap-on assembly
Order no. 8000 010 791 Support for 35mm snap-on assembly for 45A and 60A
Order no. 2000 000 841 Bus module Profibus DP
Order no. 2000 000 842 Bus module Modbus RTU
Order no. 2000 000 848 Bus module connector cable for 4 conntrollers, 2.5m long
Order no. 2000 000 849 Bus module connector cable for 4 conntrollers, 1.5m long
➜

13. Approvals and conformities

The following approvals and conformities are available for Thyro-A
• Quality standard according to DIN EN ISO 9001
• UL registration, file no. E 135074, under preparation, with consideration to
Canadian National Standard, project no. 02ME08043
• CE conformity
• Low voltage directive 73/23 EEC
• EMV directive 89/336 EEC; 92/31 EEC
• Marking directive 93/68 EEC
Guidelines
The CE mark on the device confirms observation of the EC general guidelines for
72/23 EEC - low voltage and for 89/339 EEC electromagnetic compatibility if the
instructions on installation and commissioning set out in the operating instructions
are observed.
There is no product norm for Thyristor Power Controllers so that a sensible norm
structure must be set up which ensures safe application and opportunity for compa-
rison.
CAUTION
Thyristor Power Controllers are not devices for disconnection in the
sense of DIN VDE 0105 T1 and may therefore be operated only in
connection with a suitable mains isolating device (e.g. switch, isolating
link).
Additional to the following table further norms are adhered to, e.g. voltage dips
according to 61000-4-11:8.94 are ignored by the control device or registered by
triggering off monitoring. Generally an automatic start is made after the mains
returns within the tolerances.
for 8A, 16A and 30A
107