Table of Contents
Advertisement
IDE Channel 0 Master and IDE Channel 0 Slave
To configure the IDE drives, move the cursor to a field then press
<Enter>. The following screen will appear.
IDE HDD Auto-Detection
IDE Channel 0 Master
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
↑↓→←
: Move
F5: Previous Values
The settings on the screen are for reference only. Your version may not be
identical to this one.
IDE HDD Auto Detection
Detects the parameters of the drive. The parameters will automati-
cally be shown on the screen.
IDE Channel 0 Master and IDE Channel 0 Slave
If you select "Auto", the BIOS will auto-detect the HDD & CD-
ROM drive at the POST stage and show the IDE for the HDD &
CD-ROM drive. If a hard disk has not been installed, select "None".
Access Mode
For hard drives larger than 528MB, you would typically select the
LBA type. Certain operating systems require that you select CHS or
Large. Please check your operating system's manual or Help desk on
which one to select.
Phoenix - AwardBIOS CMOS Setup Utility
IDE Channel 0 Master
Press Enter
Auto
Auto
Enter: Select
+/-/PU/PD: Value
F6: Fail-Safe Defaults
COM Express Board
Menu Level
To auto-detect the
0MB
HDD's size, head... on
this channel
0
0
0
0
0
F10: Save
ESC: Exit
F7: Optimized Defaults
Item Help
F1: General Help
35
Advertisement
Table of Contents
