Hangar 9 PT-19 Instruction Manual page 9

Section 2: Joining the Wing Halves
Step 6. Place one wing half right side up on a flat work surface.
Use a scrap piece of wood or an epoxy brush and smear a gen-
erous amount of epoxy into the wing dihedral brace cavity in the
wing panel.
Step 7. Coat one half of the dihedral brace with epoxy on both
sides, up to the pencil line drawn in Step 1. Note the orientation of
the wing brace — the "V" points to the top of the wing, or faces
up, when the wing panel is placed on the workbench top-side up.
Install the epoxy-coated half of the dihedral brace into the wing
joiner cavity of the wing panel, up to the centerline, making sure
the "V" of the dihedral brace is orientated correctly. Use rubbing
alcohol and a paper towel to clean up any excess epoxy.
Step 8. Apply a generous amount of epoxy into the wing brace
cavity of the other wing panel.
Note: You'll need to mix up an additional 1-2 ounces of
epoxy to complete the wing joining process.
Step 9. Next, apply epoxy to all sides of the exposed area of the
dihedral brace and uniformly coat both wing roots with epoxy.
CONTINUED
9