Parts Needed; Tools And Supplies Needed - Hangar 9 PT-19 Instruction Manual

Parts Needed

Aileron Extension (2) (JRPA114, 12" Silver)
Propeller
Foam for cushioning tank
Fuel tubing (use gas fuel tubing for gas engine)
Fuel Filter

Tools and Supplies Needed

Adhesives
Thin CA (cyanoacrylate) glue
Thick CA (cyanoacrylate) glue
6-minute epoxy
12-minute epoxy
30-minute epoxy
Blue Threadlock Z-42
Canopy glue (R/C 56)
Silver solder (Stay Brite)
Tools
Drill
Drill bits: 1/16", 1/8", 5/32", 1/4", 3/8"
Soldering iron
Small Phillips screwdriver
Medium Phillips screwdriver
Z-bend pliers
Pliers
1/16" hex wrench
Small round file
Moto-Tool with sanding drum
Hobby knife with #11 blade
Mixing stick
Epoxy brush
90-degree triangle
Sanding sticks (medium)
Medium sandpaper
Masking tape
Straight edge
Measuring device (e.g., ruler, tape measure)
Scissors
Paper towels
Wax paper
Rubbing alcohol
Felt tipped pen or pencil
Optional Equipment
Radio packing foam
Antenna tube
4
Fueler Valve
Kill switch and hardware (if using a gas engine)