Replacing Motor Brushes; Replacing Electrical Controls - Shop fox M1015 Instruction Manual

M1015 6" x 10" Mini-Lathe
Replacing.Motor.Brushes
Should.you.ever.need.to.replace.the.motor.brushes,.
do.these.steps:.
1. UNPLUG.THE.LATHE!
2. Unscrew four Phillips screws and remove the splash
guard.
3. Unscrew two brush holders and replace the brushes
in the brush bore (see Figure.28).
4. Reinstall the brush holders and the splash guard.
Replacing.Electrical.
Controls
The following is a list of the electrical components that
control motor operation. Electrical repairs are made by
unplugging the lathe, removing the control panel or the
circuit board panel, and replacing the electrical part at
fault. Refer to the list below for description and part
number, and see Figures.29.and.30 for part location.
. . . .
A. Fwd/N/Rev Control Switch (XM1015168) ..............1
B. Green Power Light (XM1015169) ........................1
C. Orange Reset Light (XM1015172) ........................1
D. Fuse and Holder (XM1015170) ...........................1
E. Spindle Speed Control Dial (XM1015166) ..............1
F. Emergency Stop Switch (XM1015167) ..................1
G. Motor Speed Circuit Board (XM1015153) ...............1
H. Chuck Guard Safety Micro Switch (XM1015131) ......1
.. ..
-27-
Brush Bore
Brush
Brush Holder
Figure.28. Motor brush and holder.
A
B
D
C
Figure.29. Control panel electrical.
H
G
Figure.30. Motor speed circuit board.
F
E