When you press the UP button or turn the PHASE knob
clockwise, the characters and symbols appear in the
sequence shown below.
Capital letters (A t B t ....... t Y t Z) t Lower-
case letters (a t b t ....... t y t z) t Numbers (0
t 1 t ....... t 8 t 9) t Marks t Capital
letters...
When you press the DOWN button or turn the PHASE
knob counterclockwise, the characters and symbols
appear in the reverse sequence described above.
The usable symbols are limited depending on the
menu.
“(space)” is not used as a first character of a sentence.
4
Press the ENTER or Ent button.
The selected character is entered.
Display example
iiChannel Name
CH01
PROG___
EDIT___
CAM___
VTR___
PREV___
New Name
C
5
Repeat steps 3 and 4 until all the characters are entered,
then press the ENTER or Ent button.
The selected characters are confirmed and the display
returns to the menu of the upper level.
To correct the entered character
Press the Del button. The character on the left side of the
cursor is deleted.
Entering the Channel Number
When selecting a one-digit number, press the button of the
channel number.
When selecting a two-digit number, first press the 0 button,
then press a two-digit channel number.
Channel numbers 91 to 97 assignment
The signal systems to which the internal signal is displayed
are assigned to channel numbers 91 to 97. The internal
signal of the last signal system is displayed.
091: PLUGE signal
092: 20% gray signal
093: 100% white signal