Sony BVM-F250 Operation Manual page 98

modes listed below. Set Right for the right signal, and Left
for the left signal.
Normal: Normal picture
Black: Displays a black signal only (the video signal is not
displayed).
Mono: Displays the video signal in monochrome mode.
Red: Displays only the red component of the video signal.
Blue: Displays only the blue component of the video
signal.
Flip H display
The input 3D video signals whose left (L) or right (R)
signal has been inverted horizontally by a half-mirror type
3D rig are displayed as non-inverted images.
Procedure
1
Input 3D video signals.
2
Set the desired display mode of the 3D signal
analyzing function (Difference, Checkerboard, L/R
Switch, Horopter Check or Flip H) to On by pressing
the function button
Function Switch menu (page 68) of the Function
Setting menu.
If the desired display mode of the 3D signal analyzing
function has been assigned to a pin of the PARALLEL
REMOTE connector, set Parallel Remote (page 74) in
the System Configuration menu to On.
1) Difference, Checkerboard, L/R Switch, Horopter Check or Flip H is
assigned to a function button of the controller in the Function Key
menu (page 84) of the Controller menu.
To stop execution of the 3D signal analyzing
function
Set Difference, Checkerboard, L/R Switch, Horopter
Check or Flip H to Off in the Function Switch menu (page
68) of the Function Setting menu. Or set the corresponding
function button of the controller to off.
The Difference, Checkerboard, L/R Switch or Horopter
Check display is returned to the normal display and the
currently selected left or right signal is displayed.
The Flip H display is returned to the normal display
without inversion.
Notes
• To use the 3D signal analyzing function, use an optional
BKM-250TG input adaptor.
The available display modes of the 3D signal analyzing
function differ depending on the serial number of the
BKM-250TG as follows:
With serial number 7100001 or higher:
– Checkerboard
– L/R Switch
– Horopter Check
– Flip H
98
Switching the Display of the 3D Video Signal
1)
of the controller or in the
With serial number 7300001 or higher:
– Difference
– Four other display modes
• To assign Checkerboard or L/R Switch to a function
button of the controller, use the controller with software
version 1.5 or higher. To assign Difference, Horopter
Check or Flip H to a function button of the controller, use
the controller with software version 1.6 or higher
• If you change the channel when the 3D signal analyzing
function is On, it is switched to Off.
• If you display the Picture&Picture image when the 3D
signal analyzing function is On, it is switched to Off.
• If the input signal system is changed when the 3D signal
analyzing function is On, the 3D video image may not be
displayed correctly.
• The 3D signal analyzing function cannot be set to On in
the following cases:
– When the option port number in which the BKM-
250TG is installed is not selected in Input Port of the
Channel Configuration menu
– When dual-link display is used
– When the internal signal is displayed
– When a captured frame is displayed
– When Side by Side is set to On
• The display of the 3D signal analyzing function may not
be performed correctly when H Delay is set to On.
• If saving is performed in HD Frame Capture when a 3D
signal analyzing function other than Flip H is in use, the
function is deactivated and the normal display is
restored.