Sony BVM-F250 Operation Manual page 68

Menu
Function Switch
Scan Mode
Native Scan
16:9
H Delay
V Delay
External Sync
68
Function Setting Menu
Function and operation ([
Sets the function to be assigned to the function button of the controller in the menu.
Sets the scan mode of the picture.
[Normal Scan]: Normal scan
Under Scan: 3% under scan
Over Scan: Mask of 5% over scan portion in the normal scan
Note
The scan mode is not selectable in the following cases:
• When Native Scan is set to On
• When the input signal has no sync signal
• When the internal signal is displayed
• When Side by Side is set to On
Sets whether or not to display the native scan ([Off] or On).
Note
The native scan is not selectable in the following cases:
• When the input signal has no sync signal
• When Side by Side is set to On
• When Pixel Zoom is set to on
• When the HDMI/DisplayPort computer signal is input (The native scan is displayed
regardless of the setting.)
• When the signal system is the SD signal of 720 × 576 or 1440 × 576, Native Scan Mode is
set to Aspect Correction × 2 and the internal signal is displayed (Native Scan is set to Off
and the normal scan is displayed regardless of the setting.)
Sets whether or not to display the aspect in 16:9 (Off or [On]).
Notes
• The aspect ratio is not selectable in the following cases:
– When Native Scan Mode is set to ×1 or ×2 and Native Scan is set to On
– When the input signal has no sync signal
• The aspect ratio may be fixed to 16:9 due to the signal format.
For details, see "Available Signal Formats" on page 114.
Sets whether or not to display in H delay ([Off] or On).
When the 720/24, 25, 30P signal is input, the display position is changed with the PHASE
knob.
Notes
• The picture is not displayed in H delay in the following cases:
– When the input signal has no sync signal
– When the internal signal is displayed
– When Format of the Channel Configuration menu is set to HDMI or DisplayPort
– When Side by Side is set to On
– When the captured frame is displayed
• The 3D signal analyzing function may not be performed correctly when H Delay is On.
Sets whether or not to display in V delay ([Off] or On).
Note
The picture is not displayed in V delay in the following cases:
• When the input signal has no sync signal
• When the internal signal is displayed
• When Format of the Channel Configuration menu is set to HDMI or DisplayPort
• When Side by Side is set to On
• When the captured frame is displayed
Sets whether or not to select external sync mode ([Off] or On) when the analog component
signal or analog RGB signal format is input.
When On is selected, the signal to be displayed is synchronized with the sync signal input to
the SYNC connector (External Sync).
When Off is selected, the signal to be displayed is synchronized with the sync signal included
in the signals being monitored (Internal Sync).
Notes
• When Component is set to YPbPr or RGB in Format of the Channel Configuration menu,
you can set the external sync.
• The external sync is not set in the following cases:
– When the internal signal is displayed
– When the captured frame is displayed
]: factory setting)