Installing The Camera Driver Using The Setup Program - Zeiss AxioCam MRc5 Installation Reference Manual

Installing the camera driver using the setup
program
NOTE:
For installation under Windows 2000 Professional and Windows XP
Professional, you need to log on with administrator privileges. If you do
not have access to administrator rights on your computer, please speak to
your system administrator.
In this section, installation is explained using screenshots from Windows
2000 Professional. However, the procedure is the same for Windows XP
Professional.
During the installation of the AxioCam MRc5, the camera's firmware is
checked and, if necessary, updated. The AxioCam MRc5 must therefore
be connected to the PC and be in 'ready' mode (green LED) during the
installation procedure.
If you have fitted a FireWire PCI bus or a PCcard (CardBus)
interface card into your computer, you first need to install these
with the help of the documentation enclosed by the manufacturer.
Depending on your operating system, this installation may not be
necessary, as the drivers may already be integrated into the
operating system.
In addition to installing the AxioCam MRc5 driver, to carry out full
installation of the camera you also need to check and, if necessary,
update the camera's firmware. These tasks are performed by the
AxioCam MRc5 installation program, which is described in this
section.
After you have inserted the CD into the CD drive installation starts
automatically.
AxioCam MRc5 Installation + Reference
Installation of the AxioCam MRc5
25