Installing The Camera Driver With The Hardware Wizard - Zeiss AxioCam MRc5 Installation Reference Manual

When installing the components it is possible that some of the files to be
installed may already exist. You are informed if this is the case. You are
then asked if you want to retain or overwrite the existing files. Always
select the answers suggested by the installation program.
Installing the camera driver with the hardware
wizard
NOTE:
For installation on a computer running under the operating system
Microsoft Windows 2000 Professional and XP Professional, you need
administrator rights. Enter the system using a user name with
administrator rights, or consult your system administrator.
The installation procedure is the same for Windows 2000 Professional and
Windows XP Professional, but is displayed in this Installation Guide with
screenshots of Windows 2000 Professional.
If you have fitted a PCI bus or a PCcard (CardBus) interface card
into your computer, you first need to install these with the help of
the documentation enclosed by the manufacturer. Depending on
your operating system, this installation may not be necessary, as
the drivers may already be integrated into the operating system.
In addition to installing the AxioCam MRc5 driver, to carry out full
installation of the camera you also need to check and, if necessary,
update the camera's firmware. These tasks are performed by the
AxioCam MRc5 installation program. This program must also be
called up after installation of the camera driver using the hardware
wizard (see the section "Installing the camera driver using the
setup program").
AxioCam MRc5 Installation + Reference
Installation of the AxioCam MRc5
21